How to apply custom limits

This help page describes how to use the custom limits feature of the Craydec Control Charts.

Requirements

  • Craydec Control Charts, version 1.2.0 or higher
  • Valid license

When custom limits are needed

Usually, control charts are used by determining the control limits (Upper and Lower Control Line for data, Upper and Lower Control Line for variance) from the data at hand. However, sometimes there arises a need to apply control lines other than from data at hand.

Custom limits are typically needed when you have the process in control, and you have already determined the control line values. Sometimes you want to use a non-standard formula, or you might use this feature to track data against specification limits instead of control limits.

How to do it

There are two ways to use custom limits.

1) Static custom limits (limits from settings)
2) Dynamic custom limits (limits from data)

Static (limits from settings)

Static custom limits are fast and easy to use, as you just enter the custom limits to the visual’s settings. However, you can enter only one set of limits, so if you are using subgrouping (steps), the same set of custom limits is applied to all of the subgroups (steps).

** Enable custom limits **
Set Settings > Custom Limits : On
Select Settings > Custom Limits > Limit Type : static

** Enter custom limits **
Enter your custom limits to the visual’s settings.
Settings > Custom Limits > UCL for data / LCL for data / UCL for variance / LCL for variance

** Notes **
The custom limit text fields appear only after you have enabled the custom limits, and selected static limit type.

If you enable custom limits, you have to provide all the limits. Control line without value is not shown at all.

If you want to enter a zero value, insert a non-zero value first, then change it to zero.

To remove control lines, click ‘Revert to default’, and enable the custom limits again.

Dynamic (limits from data)

Dynamic custom limits are a bit more difficult to set up that the static limits, but it allows you to drive the visual from your data. This makes it possible to control the visual from your backend, for example by (re-)calculating the limits in the database.

** Enable custom limits **
Set Settings > Custom Limits : On
Select Settings > Custom Limits > Limit Type : dynamic

** Select data **
Select variables/columns for data roles (Custom UCL & LCL, Custom UCL & LCL for variance)

** Requirements for data **
There are some special considerations for the data used for custom lines.

1) Data type must be number.
2) The first line of a subgroup (step) must contain the custom line
values. If a value is not found the control lines are not drawn. To be on the safe side, repeat data for each line of a subgroup (step).
3) For S-, and R-charts the first line of subgroup (sample) must contain the custom line value for a datapoint. If a value is missing, the control line is now drawn.

** Example data **

Example data

When using subgrouping (steps), subgroup data role must be used to indicate a new subgroup. The same variable/column that is used for custom lines, can be used. Each change in value starts new subgroup.

In the picture above, the black rectangles indicate a new subgroup (step) start, and the limits used for the subgroup.

Examples

Download example report, and enter a valid license code to see the custom limits in action.